Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving all 50 states, DC & Puerto Rico
(833) 435-8883

Hörmann Torsion Spring Replacement in Your Area

Torsion springs replaced and wound correctly, with high-cycle upgrades available. Typical cost $200-$450.

Call (833) 435-8883Instant quote

From the first phone call to the final safety test, Hörmann torsion spring replacement in your area follows a simple process: diagnose, quote, repair, test. Torsion springs replaced and wound correctly, with high-cycle upgrades available. Our technicians service Hörmann garage doors regularly and know where the model and date labels are, which makes ordering the right part quicker. Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Signs you need Hörmann torsion spring replacement

  • A gap in the spring mounted on the bar above the door
  • The door slams shut or won't stay open
  • Only one side of the door lifts and the door goes crooked
  • The door is suddenly too heavy to lift by hand

What usually causes it

  • Normal fatigue at the end of the spring's rated cycles
  • Rust or lack of lubrication
  • An undersized spring working too hard
  • A door that's been made heavier with insulation or new panels

Safe checks before you call

  • Count the springs above the door. Two-spring doors should have both replaced together.
  • Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
  • Note how often the door is used each day so the right cycle rating can be chosen.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our Hörmann torsion spring replacement process

  1. Clamp the door and unwind the old springs with proper winding bars
  2. Measure wire size, inside diameter and length, and weigh the door
  3. Install correctly rated springs, upgrading to high-cycle if you use the door a lot
  4. Wind to the right number of turns and set the door's balance
  5. Lubricate, adjust the cables and test the full travel

Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.

Typical Hörmann torsion spring replacement prices

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Hörmann services

Hörmann Torsion Spring Replacement in your area

We provide Hörmann torsion spring replacement across all 50 states, Washington, DC and Puerto Rico. Pick your state to see local details:

Hörmann Torsion Spring Replacement: frequently asked questions

How much does Hörmann torsion spring replacement cost?

Hörmann Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Hörmann torsion spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Hörmann torsion spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Hörmann warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where your state or city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Your Area

Marantec Smart Garage Door Opener Setup

Marantec is a German manufacturer of residential and commercial door openers.

Typical $100-$900

Wood Garage Door Repair

Rotted, warped or split wood sections repaired, sealed and rebalanced.

Typical $200-$700

Overhead Door Extension Spring Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$350

Moore-O-Matic Remote & Keypad Programming

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $50-$150

Haas Door Extension Spring Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$350

Richards-Wilcox Off-Track Garage Door Repair

Doors that have come off their tracks secured, re-hung and realigned.

Typical $175-$450

Linear Opener Gear & Sprocket Replacement

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $125-$275

Genie Remote & Keypad Programming

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $50-$150

Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Clopay Garage Door Cable Repair

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$350

Garaga Garage Door Track Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$400

Holmes Garage Door Off-Track Garage Door Repair

Doors that have come off their tracks secured, re-hung and realigned.

Typical $175-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician near you now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call (833) 435-8883Book a visit
Call NowFree Quote